Megaimpulse Ltd. NPG-15/2000 Manual do Utilizador

NANOSECOND PULSE GENERATOR NPG-15/2000(N) USER MANUAL © 2013 Megaimpulse Ltd.

Step 5. Switch on the high voltage by HV ON/HV OFF switch. The output high voltage pulses should be generated. Increase the amplitude and fre

OVERHEAT MODE NPG-15/2000(N) generator has 75 Ohm impedance coaxial output connector. If the generator operates on unmatched load with impedance not

generator, i.e. internal generator frequency sets the upper limit for external triggering pulses frequency. Please rotate FREQUENCY reg

Copyright © 2013 MEGAIMPULSE Ltd. All Rights Reserved. MEGAIMPULSE LTD. PROVIDES THIS MANUAL "AS IS" WITHOUT WARRANTY OF ANY K

CONTENTS Package content ... 2 General view of NPG-

PACKAGE CONTENT Please check the package for the following items:  NPG-15/2000(N) nanosecond pulse generator (hereinafter "generator"

SAFETY MANUAL Electrical safety  NPG-15/2000(N) generator is high voltage equipment. Please be very careful and operate by qualified perso

TECHNICAL SPECIFICATION OF NPG-15/2000 NANOSECOND PULSE GENERATOR Output pulse voltage Regulated 13 - 18kV at matched 75 Ohm load, up to 36kV at

FRONT VIEW 2 4 5 6 7 8 9 10 REAR VIEW 1 3

PUTTING THE GENERATOR INTO OPERATION Please follow strictly the described steps. It helps to prevent damage of the generator, other equipment, and

Step 4. Connect the other side of coaxial cable to the load. The cone teflon insulator is used at the cable end to prevent the discharge between cent